BMW – K 1600 GTL
www.vizi-tec.com Tail Light modulator installation
Part 1:
Before starting the installation please verify the operation of the brake lights.
Remove 4 screws from rear mudguard/fender to access tail light connector.
Remove OEM connector and install SBx in-line with matching connectors.
The SBx is now installed. Test the functionality of the SBx. Secure with
provide tie wraps. Put bike back together.
Proceed to part 2 of the installation only if you want to also modulate the
top-case.
BMW – K 1600 GTL
www.vizi-tec.com optional Top Case brake light modulation
Part 2:
DO THIS MOD ONLY AND ONLY AFTER YOU HAVE READ AND UNDERSTOOD HOW THE SB2/3 WORKS AND AFTER YOU HAVE VARIFIED THE
SB2/3 WORKS ON THE STOCK TAIL LIGHT! This mod is offered as a courtesy to the SBx-K1600 kit.
If you want to modulate the Top Case luggage rack of the K1600 GTL (optional for the K1600GT). Find the stock 10 positions round connector. See pics below. This is
the round connector that interfaces the top luggage case lights to the main electrical harness of the bike. Cut and splice into position #3. The wire should be Gray
with Black tracer and Yellow dots(Brake light). But this is not always constant from bike to bike. Could be different color. Just make sure it is position #3.
Make cut and splice on the BIKE SIDE of the connector set. This will allow for easy future install/removal of Top Case
MALE
10
position
round
Top Case w/
brake lights
FEMALE
10
position
round
Posi-lock
1. CUT wire from position #3 and
splice with included posi-lock to the
extra modulated output of the SB2.
FEMALE 6 position
square connector
MALE 6 position
square connector
FEMALE 6 position
square connector
SB2
< From bike harness >
Stock Tail light. Connector is integrated.
MALE 6 position
square connector
2. Stock brake signal after CUT. Terminate using
included Posi-lock to protect against shorts. Leave
floating. Or it may need to be terminated to
ground with a load resistor. Size will depend on
the current draw of your top-case. Usually
~200mA.
Main
Tail Lights
BLUE = stock existing hardware
RED = Vizi-tec mod hardware
Visit us at www.vizi-tec.com for user manual or other information.
BMW – K 1600 GTL
www.vizi-tec.com optional Top Case brake light modulation
BEFORE:
AFTER:
Cut wire #3, gray with black stripes and yellow dots. Secure the white
wire from SBx to the #3 wire on the bike side of the 10 pin connector
with a posi-lock. Use another posi-lock to secure the now open #3 gray
wire coming from the bike's wiring harness.